When aches or pains arrive, it is common to reach for NSAIDs, like aspirin or ibuprofen. They are easily accessible and have long been considered relatively safe. But the chronic, or long term, use of these pain relievers can have a very negative effect on your health. Use of NSAIDs in older adults has been found to increase the risk of peptic ulcers, acute renal failure, and stroke or myocardial infarction.
Hemp does best on a loose, well-aerated loam soil with high fertility and abundant organic matter. Well-drained clay soils can be used, but poorly-drained clay soils are very inappropriate because of their susceptibility to compaction, which is not tolerated. Young plants are sensitive to wet or flooded soils, so that hemp must have porous, friable, well-drained soils. Sandy soils will grow good hemp, provided that adequate irrigation and fertilization are provided, but doing so generally makes production uneconomical. Seedbed preparation requires considerable effort. Fall plowing is recommended, followed by careful preparation of a seedbed in the spring. The seedbed should be fine, level, and firm. Seed is best planted at 2–3 cm (twice as deep will be tolerated). Although the seedlings will germinate and survive at temperatures just above freezing, soil temperatures of 8°–10°C are preferable. Generally hemp should be planted after danger of hard freezes, and slightly before the planting date of maize. Good soil moisture is necessary for seed germination, and plenty of rainfall is needed for good growth, especially during the first 6 weeks. Seeding rate is specific to each variety, and this information should be sought from the supplier. Fiber strains are typically sown at a minimum rate of 250 seeds per m2 (approximately 45 kg/ha), and up to three times this density is sometimes recommended. In western Europe, seeding rates range from 60–70 kg/ha for fiber cultivars. Recommendations for seeding rates for grain production vary widely, from 10–45 kg/ha. Densities for seed production for tall, European, dual-purpose cultivars are less than for short oilseed cultivars. Low plant densities, as commonly found in growing tall European cultivars for seed, may not suppress weed growth adequately, and under these circumstances resort to herbicides may pose a problem for those wishing to grow hempseed organically. Hemp requires about the same fertility as a high-yielding crop of wheat. Industrial hemp grows well in areas that corn produces high yields. Growing hemp may require addition of up to 110 kg/ha of nitrogen, and 40–90 kg/ha of potash. Hemp particularly requires good nitrogen fertilization, more so for seed production than fiber. Adding nitrogen when it is not necessary is deleterious to fiber production, so that knowledge of the fertility of soils being used is very important. Organic matter is preferably over 3.5%, phosphorus should be medium to high (>40 ppm), potassium should be medium to high (>250 ppm), sulfur good (>5,000 ppm), and calcium not in excess (<6,000 ppm).
Until recent times, the cultivation of hemp primarily as an oilseed was largely unknown, except in Russia. Today, it is difficult to reconstruct the type of plant that was grown there as an oilseed, because such cultivation has essentially been abandoned. Oilseed hemp cultivars in the modern sense were not available until very recently, but some land races certainly were grown specifically for seeds in Russia. Dewey (1914) gave the following information: “The short oil-seed hemp with slender stems, about 30 inches high, bearing compact clusters of seeds and maturing in 60 to 90 days, is of little value for fiber production, but the experimental plants, grown from seed imported from Russia, indicate that it may be valuable as an oil-seed crop to be harvested and threshed in the same manner as oil-seed flax.” Most hemp oilseed in Europe is currently obtained from so-called “dual usage” plants (employed for harvest of both stem fiber and seeds, from the same plants). Of the European dual-usage cultivars, ‘Uniko B’ and ‘Fasamo’ are particularly suited to being grown as oilseeds. Very recently, cultivars have been bred specifically for oilseed production. These include ‘Finola,’ formerly known as ‘Fin-314’ (Fig. 6) and ‘Anka’ (Fig. 7), which are relatively short, little-branched, mature early in north-temperate regions, and are ideal for high-density planting and harvest with conventional equipment. Dewey (1914) noted that a Turkish narcotic type of land race called “Smyrna” was commonly used in the early 20th century in the US to produce birdseed, because (like most narcotic types of Cannabis) it is densely branched, producing many flowers, hence seeds. While oilseed land races in northern Russia would have been short, early-maturing plants in view of the short growing season, in more southern areas oilseed landraces likely had moderate height, and were spaced more widely to allow abundant branching and seed production to develop. Until Canada replaced China in 1998 as a source of imported seeds for the US, most seeds used for various purposes in the US were sterilized and imported from China. Indeed, China remains the largest producer of hempseed. We have grown Chinese hemp land races, and these were short, branched, adapted to a very long growing season (i.e. they come into flower very slowly in response to photoperiodic induction of short days in the fall), and altogether they were rather reminiscent of Dewey’s description of Smyrna. Although similar in appearance to narcotic strains of C. sativa, the Chinese land races we grew were in fact low in intoxicating constituents, and it may well be that what Dewey thought was a narcotic strain was not. Although some forms of C. sativa have quite large seeds, until recently oilseed forms appear to have been mainly selected for a heavy yield of seeds, usually recognizable by abundant branching. Such forms are typically grown at lower densities than hemp grown only for fiber, as this promotes branching, although it should be understood that the genetic propensity for branching has been selected. Percentage or quality of oil in the seeds does not appear to have been important in the past, although selection for these traits is now being conducted. Most significantly, modern selection is occurring with regard to mechanized harvesting, particularly the ability to grow in high density as single-headed stalks with very short branches bearing considerable seed.
Now imagine all this possibility actually exists but you can't enjoy any of it because people in power once decided the plant from which it's all derived has a scorned cousin named "marijuana." If you can wrap your mind around this dereliction of logic, only then can you begin to understand the painfully silly policies America's had in place that have kept hemp from coating our farmland with hues of pale yellow and light green.
A few years ago, the National Academy of Medicine convened a panel of sixteen leading medical experts to analyze the scientific literature on cannabis. The report they prepared, which came out in January of 2017, runs to four hundred and sixty-eight pages. It contains no bombshells or surprises, which perhaps explains why it went largely unnoticed. It simply stated, over and over again, that a drug North Americans have become enthusiastic about remains a mystery.
Hemp Seed Oil is derived from the hemp seeds and are mainly used for dietary purposes (imagine something similar to coconut oil). Refined hemp seed oil can also be used in beauty care products, as they have amazing skin care properties. CBD Hemp oil is not the same thing as hemp seed oil, as it is extracted from one of hemp’s many cannabinoids and have fundamentally different properties.
Some CBD manufacturers have come under government scrutiny for wild, indefensible claims, such that CBD is a cure-all for cancer, which it is not. We need more research but CBD may be prove to be an option for managing anxiety, insomnia, and chronic pain. Without sufficient high-quality evidence in human studies we can’t pinpoint effective doses, and because CBD is currently is mostly available as an unregulated supplement, it’s difficult to know exactly what you are getting. If you decide to try CBD, talk with your doctor — if for no other reason than to make sure it won’t affect other medications you are taking.
In a SAFEX study of Phase III double-blind RCT in 160 subjects with various symptoms of MS (Wade et al 2004), 137 patients elected to continue on Sativex after the initial study (Wade et al 2006). Rapid declines were noted in the first twelve weeks in pain VAS (N = 47) with slower sustained improvements for more than one year. During that time, there was no escalation of dose indicating an absence of tolerance to the preparation. Similarly, no withdrawal effects were noted in a subset of patients who voluntarily stopped the medicine abruptly. Upon resumption, benefits resumed at the prior established dosages.